General Fishing Discussion > Bait, Tackle, Rods and Reels etc… | Menu
Next

Author:
AVec80X
Date:
May 06, 2014
Subject:
Rod Repair/Refurbishing in CT
Message:
Does anyone on here repair/refurbish rods? or know of somebody in CT that does? I have a late 60's Wright & McGill Co / Eagle Claw Denco - 7 ft Spinning Rod that I would like to put new guides on since the old ones are rusty and ready to snap off. It's a family hand-me-down that I can't part ways with and would like to refurb and use from time to time. Thanks in advance for any info.
Author:
Redneckangler
Date:
May 06, 2014
Message:
Most all shops do this. Fishing Factory 3 is out near you. Give 'em a call. If you're a DIY guy, it's not a very difficult project with plenty of step by step videos online.
Author:
ripline
Date:
May 06, 2014
Message:
If not FF3 then Rivers End in Old Saybrook. They do a lot of rod work there.
Next
Home | Topics | Menu